Chosen Solution
Hello! my Krups Nespresso Inissia XN 100 machine after heating up keeps blinking with the following sequence: 3 fast 1 pause. The assistance said that there is an error in the electronics. Any suggestions rather than getting rid it of my poor Nespresso?
@leoborni see if it is stuck in descale mode. Press both green lights for 3 secs and it should flashing at a slower rate. When they stop flashing it should be good to go.
I’m my case it was the water container had leaked water into the hole underneath, I had descaled using vinegar then done all the cleaning and flushing only for it to start flashing continuously. I removed the water container dried it out and now all fine again, coffee back. It was in the hole not in the round gully that the container sits in. It worked for me hope it works for you.
Just wanna ask, have any of you found the solution?
In my case, (after speaking with support) I was told the coffee maker doe not work with power from an inverter, like in a motor home. Oh well. Returned it.
I just had the same problem, both lights would keep flashing 3 times. Tried pressing them both, pressing one,…. Nothing would work. Switched it off at the wall, waited 5 seconds and switched it back on… Works perfectly now
In my case, after reading here, I removed the water container dried the hole put container back and turned it on and it worked fine.
