Chosen Solution
I have a whirlpool dishwasher that is several years old. The model is WDT720PADW1. Earlier this year I replaced the diverter gasket and now it has started overflowing from the front of the tub. I almost always run the sensor/normal cycles. When I run the 1 hour quick wash cycle it does not overflow. Fortunately this works most of the time, but doesn’t always clean the dishes well enough. Prior to discovering the fact that the one hour cycle doesn’t leak I have checked the float, switch and lever. All are functioning as I would expect them to. I can actually see it overflow when it is running a wash when I had the door cover off. I also checked the arms for cracks or extra places where water would shoot out the side, but this is still not consistent with the different cycles. What are my next steps and things to check? I’m at a loss and wondering if there is an issue with the control board.
Hi @thedipsman , Try running a diagnostic cycle and check for any error codes. Here’s a link that describes how to enter diagnostics mode. Not your exact model but should be close enough
