Chosen Solution The ports that are used to connect the wireless cards, is there an extra one? Hi, Looking at the systemboard in the service manual for your laptop series there are no spare PCI connectors available. Here is the link to the service manual, scroll to p.63, the existing wireless module is shown just above the coin cell battery. http://downloads.dell.com/Manuals/all-pr…
Chosen Solution Hi, I have a Nintendo 3ds and the down button does not click anymore. I want to know if it’s grave and what can cause it. My X button works also 1 time on 2. Please help me! You may want to open it up and see if the gaskets are being interfered with at all. There’s a repair guide for that area here: Nintendo 3DS XL Power Button Replacement....
Chosen Solution a friend of mine fell off her bike onto her SE 2020 and i(poorly made decision) tasked myself with repairing it. I’ve had to replace both the screen and body of the phone and now it somewhat usable but has two MAJOR issues that i can’t figure out. that being that the phone refuses to charge unless turned off, and that the phone will repeatedly just constantly reboot every 6 or 7 minutes....
Chosen Solution Hi all - First time poster. We just purchased a house which was built in 2000 and contains the original appliances. So 16ish years old, and seem like nice appliances. Full GE Profile suite of fridge, dishwasher, and oven. Everything has been fine with our fridge/freezer our first 30 days in the house, but this morning I woke up to the freezer jumping from 0 degrees to 45. The fridge not so bad - 36 to 39....
Chosen Solution bought used from habitat for humanity and transported it on its side(fridge not freezer side) Was told to let it si t24 hrs so the refrigerant oil can settle. It gets slightly cool but not cold. Did I ruin it? Most Frequent Causes for Refrigerator not cooling Cause 1 Condenser Coils are Dirty The condenser coils are usually located under the refrigerator. They dissipate heat as refrigerant passes through them....
Chosen Solution Lately, I notice more and more condensation on the shelves suggesting this has been ongoing. I brushed off the coils on the back ( not much dust) unplugged and reset to zero. After plugging in it’s working again. I set the temps in the middle ( 0-7) and its cooling and freezing. I can’t hear the freezer fan which makes me believe it hasn’t been working since the foods on the top shelf don’t freeze properly....
Chosen Solution I have a GE Monogram Built-In Oven with Advantium® Speedcook Technology- ZSC1001KSS01 There are two bulbs inside (not the door bulb, but heating bulbs). The HEATER HALOGEN bulb works fine when applicable settings are used. The HEATER MIRACLON bulb never seams to be used, or at least I can’t figure out what settings use that bulb. My question is… what it HEATER MIRACLON bulb used for? I’d rather ask first as to what it’s used for before taking it all apart....
Chosen Solution I was advised to buy the hakko fm-202 as I would like to learn micro soldering. However, it seems quite difficult to get this, as I’m in the UK. And it seems as if these are discontinued, and don’t really fancy getting a second hand one (the ones I’ve seen look very tatty) Is there another good alternative that I can use in the UK (240v) And suitable attachments....
Chosen Solution So here’s the problem, I’ve got a media player with a 2TB hard drive inside it and I want to start using it as an external hard drive instead but, if I take the hard drive out and connect it to a SATA to USB cable, the hard drive doesn’t even turn on. I’ve checked it when it’s connected in the media player and it works completely fine, I can look at the files inside and everything....
Chosen Solution I building a hot rod Beige G3 for a customer. I’ve built one of these for him before but forgotten a lot about these machines because it’s been ten years +. Using 10.2.8. Sonnet 1GHz G4 CPU. 768 Megs of RAM. Bus one, a 120 HD formatted 2 partition to a 7.5 GB with the systems on it and 112 GB as storage. The second hard drive, 500 Megs, was formatted on a MDD to be able to see past the 128 Meg limit....
Chosen Solution I have a mid 2011 iMac 27inch i7 3.4 . I am wondering if anyone has considered fitting dual SSD hardrives in the existing hard drive bay? Without doing the teardown and then seeing if it fits, I would like to find out first. Could there be a build up of heat in this area? Can anyone see any other problems? Here’s the Dual hard drive kit: Installing iMac Intel 27" EMC 2429 Dual Drive Kit (HDD or SSD) It also has an SD card slot....
Chosen Solution I’m using a translator. Please understand. My laptop fell to the ground, and the audio circuit parts fell off. So I’m trying to replace the part, but I don’t know exactly what it is. It looks like a transistor or a mosfet. Because the leg of the part is broken, I won’t solder it with that part. Just tell me exactly what that part is. ge62 schematic : https://www....
Chosen Solution Hi, after battery failure (it blow up), the internal home button connector bend and broke (in particular one of the two little connectors showed in picture above). Do someone know how is this component called (the board I mean)? Thank you You’ll need to replace the Lightning Assembly (charge Port Flex). Check out this guide.
Chosen Solution Hello, Recently, I replaced the charging port on an iPhone 7. I disconnected the battery, then the screen, and from then just continued disassembling the logic board. The repair went well, and the charging port now works. The only problem is that now the home button does not work. I am frustrated because I did not do anything to the screen, only disconnect it. I’ve had to use a JC home button (bluetooth version) as a temporary fix....
Chosen Solution This is a follow up question from my previous question about a water damaged phone. You can find that by searching in my questions. To summarize, the iPhone I’m trying to repair would shut off or wouldn’t turn on unless the home button/touch ID was disconnected. I thought it was the phone until I swapped the LCD and everything works. Mind you, it was under water but with the LCD swap, everything works....
Chosen Solution I have a place where I can get the chair reupholstered. However the upholsterer wants the wooden legs and arms and wings refinished first. Should I just go to a local carpenter or sand them out and refinish them myself considering they are kind of intricate? Do I need to take it apart first or will this make it harder on the upholsterer to complete her job? Anyone with experience to share on this would help....
Chosen Solution The microphone on huawei honor 3c doesn’t work I can’t record my voice When I make a phone call no one here my voice but I here them very good My phone fell on the ground to day Hi, Connect the earphones with the microphone attachment and either make or receive a call. If your voice can be heard then the voice transmission circuitry of the phone is OK but there is a problem with the microphone....
Chosen Solution I was plastidipping my lid, and it didn’t work out that great because of the stickers I had on. I took all the plastidip off, but there is still some in the cracks between the aluminum lid and plastic/glass light up apple logo. I really want to clean it off because my OCD is really really bothering me about it. I can provide pictures of it if you want....
Chosen Solution Asus laptop ModeK53E-RBR9 probably has a loose connection in the power port. Power cable plugged in does not charge battery, but if cable is held at an angle towards back of laptop, then it does. Can the power port be accessed, repaired or changed? Hi @beetle1 , Here is a video which shows how to dis-assemble a K53E/X53E laptop. At approx. the 7:53 minute mark into the video the motherboard can be removed so access to the DC-In jack is possible....
Chosen Solution iMac “Core 2 Duo” 3.06 24-inch (early 2008) This is my first try with an iMac, helping a friend replace the hard drive… I usually do PC stuff.. I followed the instructions and replaced the Hard Drive in the iMac with a Western Digital 1 TB Desktop SATA drive. It went in flawlessly. Now I need to FORMAT the new HD. Can someone give me step by step instructions on how to do this?...
