Chosen Solution Can anyone tell me where or post a photo of the iPhone 6 Plus showing ( if the 6 plus has this same circuit) where on the 6 plus MB the U2013 version of this circuit for the iPhone 6plus is located at, and what it’s correct name is, and if the 6 plus can be fixed the same way the iPhone 6 is repaired? Thanks, Gary Hi Gary....
Chosen Solution Hey everyone. I’m attempting to restore my old game gear. When I opened the system it became instantly clear as to why it had died in the first place. One, or a few, of the old capacitors had leaked and corroded in a small section of the logic board. I was able to get the majority of the material off the board by wiping it away with Qtips. However, in the process two small pieces fell off the board....
Chosen Solution Any suggestions on who to use for glass replacement. You need to call local repair shops in your area, but they will charge more than $150, because the part sits around $175-$200 just for an LCD/Digitizer combo. Just the glass, they’ll probably charge around $130-$140 because the labor is intensive and the repair is difficult, but the part is cheap. But doing just a glass repair doesn’t look as nice as you’d expect after the repair....
Chosen Solution good morning i have a samsung galaxy A3 2016 I would like to know how to change microphone in samsung I call and do not hear me thank you. ΝΙΚΟΛΑΟΣ ΤΣΑΜΟΥΡΤΖΗΣ the mic is on the side key flex. Follow this video to get into your phone. You are looking for something like this
Chosen Solution dell optiplex 790 Im looking to upgrade my graphics card on the optiplex 790 i saw on other forums that i would be limited on the cards that i could use because the motherboard allows 35 watt usage but that if i upgrade my psu then it wouldnt be a problem. I dont know much about computers will i be able to upgrade my graphics card or not?...
Chosen Solution i wanted to know if it was possible to use a new type of hard drive with the ipod and still have it work. i saw this toshiba one but am not sure if it needs to be the hard drive specifically made for that ipod in order to work. http://www.geeks.com/details.asp?InvtId=… brandon, , the drive you picked does notwork. The interface is wrong. Your model iPod uses a ATA-6 interface with pins, not a ZIF socket....
Chosen Solution My boss told me about a tool used to hold an iPhone screen up when doing iphone repairs, basically something that connects the screen to the back housing and keeps the screen up and in place while work is being done. I can’t think of the name of it, or find it anywhere. I saw someone using one recently on the ifixit instagram, I can post the image so you get an idea of what I’m talking about....
Chosen Solution So my headphones work in my phone for everything except sound! I can control the volume, I can use them to talk to people or google assistant but there is no soun coming from them. The headphones work perfectly with my laptop and partner’s phone, the sound comes through great. I have tried starting phone in safe mode to see if that helped but nothing, I have cleaned the jack as well as I could and nothing....
Chosen Solution Hi, I have recently replaced the screen of my iPhone 6 with a cheap replacement part from AliExpress (it had good reviews). First thing I noticed is that the phone is now a bit thicker but in a shop I was explained that this can happen with replacement parts (I wasn’t aware of that). No biggie, I can live with that. More problematic is that the battery drains super quick (it barely charges while switched on) and the top-right corner of the device (looking from the front) becomes very hot....
Chosen Solution Look at the attached picture what happened to my phone. It fell and now I can see only 2/3 of the screen! Do I need to change the digitizer? The LCD screen? Both? Any advice would be greatly appreciated. shia10 This is an LCD fault not a digitizer issue. Replace the display assembly unless you have experience with separating it etc.
Chosen Solution How do you adjust screen sensitivity on the sero 8. Mine jumps all around Hi, Under Settings > System > Accessibilty try adjusting either: Touch and Hold Delay or Magnification Gestures
Chosen Solution I followed this guide and now my home button has stopped working :-( (Does not work at all for touch ID or as a physical button) I was EXTREMELY careful in all steps. What do I do?! I would check the following: • Is the home button bracket properly installed? • Is the flex or button damaged in any way? • Check the FPC connectors between the Home Button flex and the Extension flex that goes behind the back-plate....
Chosen Solution I need replacing coin cell. I started it by instructions of manual. I was disturbed because by instructions I need remove all hardware. By instructions it’s not too heavy. Now I see it’s very heavy. May be I misunderstood something and there is a much more easier way? @ibolya that is correct. This is due to the location of the battery. Sorry but there is no easier way.
Chosen Solution I want to know if I can do it and, if so, how to upgrade the RAM memory of my computer. Specifically I want to know the steps I need to follow and what kind of memory I need to buy. Hi @maupalo Based on crucial website, there seems to have options to upgrade your computer RAM http://www.crucial.com/usa/en/compatible… Your HP - Compaq Pavilion 13-s128nr x360 Convertible system specs as shipped memory Maximum Memory:8GB Standard Memory:8GB removable Slots:1 (1 bank of 1) To confirm before you proceed to purchase the memory, shut down the laptop and flip to the back, open up the screws behind to expose the mainboard, you should be seeing RAM slot compartment....
Chosen Solution Your customer service page doesn’t work I have a ( - ) 1.0 bit that’s bent and I want to use my warranty to have it replaced/fixed… how do I use it if http://help.ifixit.com/ doesn’t work? @stratoside sorry but people on here are volunteers and not connected to iFixit as a business. For help with your issue contact the iFixit staff on here http://help.ifixit.com/collection/130-co… They are very receptive and will get you straight in no time at all....
Chosen Solution My MacBook has died. It’s a white one which I bought in 2009. The sales assistant in the Apple Store tried to recover it but without any luck. I’ve got 15000 photos on the hard drive. He suggested I buy a caddy case, remove the hard drive from the Mac and try to transfer the photos to the new Mac I’ve bought. Anyone know how to do this and what caddy case I should buy?...
Chosen Solution My wife and I have a Droid Ultra / Droid Maxx (MOTXT1080) and the following happened: When I was playing a game on my Maxx, I noticed the battery was at 34%. I plugged in my charging cable and the phone was dinging (noise it makes when the charging cable is plugged in), and it was going back a forth that it was connected and then not connected. I set my phone down and when I picked it back up again in a few minutes, the screen was blank....
Chosen Solution Spilled coffee on my 2008 version black MacBook. Came back to life in 12 hours. Worked fine for 6 more months. Crapped out suddenly. Mac told me price to fix would be $850. Bought a new MacPro instead for around $1,000, but would like to fix my old MacBook as a back up. Any ideas on how to do so for around $500? Coffee is bad…first off, but apparently you did not have any sugar in it or spilled such a little amount that your computer still worked for so long after it… Here’s what i do frequently when a customer has this issue…If you remove your macbooks top-case, and take a spray non-conductive electronics cleaner and lightly spray the logic board, then take a soft toothbrush and scrub the board, especially over spots where you see some spill residue, take out the ram and scrub it with the toothbrush too (Dont worry, you wont hurt it!...
Chosen Solution Recently changed the battery from my recent purchase and using instructions from ifixit but Droid Turbo 2 still does not charge or hold power. Kevin Cowell “does not charge or hold power” are two separate things. “holding power” is part of the battery. If your phone does not charge your battery, it will not hold anything. So , since you have a new battery the failure would (should) be somewhere else....
Chosen Solution Ive ran into several instances where as i come to the final step of laying the digitizer back into the frame of the unit, the digitizer all of a sudden freaks out. When i say freak out i mean, it starts pulling the screen left and right, pressing buttons and generally acting like a defective screen. The funny thing is it only acts in this manner as soon as you get into the last 10 degrees of angle when you are laying it into the frame....
