Chosen Solution My wife’s K88H Smartwatch seems to have all its apps working but shows an incorrect time 4hrs + behind current time. I cannot seem o pair it properly with my mobile on Bluetooth. How can I change the time on it? Hi, The watch needs to be connected (paired) to a mobile phone so that it can ‘sync’ the time with the phone. What type of phone are you trying to pair the watch with?...
Chosen Solution My laptop screen is flickering, This is a problem I’ve had for several months now but has started getting bad. The driver is updated, and I already did a system restore. I think it might be the wire, how would I fix this? Hi @ghostie , Here’s a link to the service manual for your laptop. Scroll to p.56 to view the necessary pre-requisite steps and then the procedure to remove the LCD unit....
Chosen Solution How do i install a new cd/dvddrive I could’t find the exact repair that you’re looking for, but they do have a teardown of this machine that might help. MacBook Pro 17" Unibody Teardown Step #12 illustrates the removal of the optical drive. This is indeed a beautiful machine, good luck with the repair. thanks
Chosen Solution 1999 honda accord The wires to the radio got cut so there is no longer a radio, since these happen the tall lights,and dashboard lights don’t work Hi Brock, Found this link which may be of interest to you. Whilst not exactly the same problem as yours it has a similar feel. See post #6 Hopefully the multiplex unit in your car was not affected when the radio wires were cut....
Chosen Solution My friend smashed her iPhone screen, not too bad and the LCD underneath was untouched. She then says about 3 weeks later it stopped charging and wouldn’t turn on. I’ve replaced the screen, plugged in (but not swapped) a new battery and charging circuitry. Plugged into a laptop and mains charger for a few hours, still no sign of life. Does anybody have any ideas. It could be possible that you have a bad battey if you are able to test the battery voltage with a multimeter that would be a start, if the battery is below 3....
Chosen Solution I plug in tablet overnight but not fully charged overnight. I turn it on and the battery runs down fast. Also the screen change to coloured lines when battery gets low. I am certain that your battery is in poor health and will need replacing. You can either take it to a reputable repair shop and have them do the repair, or, it seems simple enough that you could possibly buy the new battery and fit it yourself :) Nextbook NXA116QC164 Display Assembly Replacement
Chosen Solution How do I inlock it toby gray, put your iPhone in DFU mode and Restore with iTunes: Connect your iPhone to your computer Turn your iPod off For 10 seconds, hold both the Home and Power buttons While still holding the home button down, release the power button only Continue to hold the home button down for an additional 10 seconds. After the dialog box explaining that the iPhone was found in recovery mode has been closed, restore your iPhone....
Chosen Solution Hi, there have been reports from people upgrading their SATA drives with SSDs not needing the OWC thermal sensor cable you mentioned. Can anyone confirm this? Is this due to the way the new iMacs are built or rather dependent on the manufacturer of the aftermarket SSD? Sorry the world is still round ;-} Haven’t done the new 2017 model, but I can tell you the older 5k still needed it....
Chosen Solution Guys i want to know whether lg g4 bootloop issue is a motherboard problem ? Also does your g4 works fine now after changing the motherboard or has it faced the bootloop issue again? first off yes it will fix the issue if it is not hardware related to anything else in the phone. to answer the question of if it will happen again. that will depend on what is causing the boot loop, majority of the time boot loops can be fixed with out changing the whole mobo or motherboard....
Chosen Solution My apple watch has not been charging. I bought a new charger to no avail. I’m planning to replace the battery. Does the battery have an inbuilt receiver coil? or do i have to buy that separate? Where is the receiver coil for the watch? I’m not sure which of the two (battery or receiver coil) is working. Many thanks in advance. Trisch Varela, if you order a replacement battery, you get the replacement battery....
Chosen Solution PLS HELP. i laready put my mobile insde a container with rice for a night. and now i tried to open it its not turning on, can someone tell me how to open the phablet or anything else i can do. thanks in advance Jan Mikhael Marzan , Do not try to charge or power up the device(doing so can damage a device further, causing short circuit), putting the device in rice would have done very little to save the device....
Chosen Solution Canon PowerShot A610. Press on/off, lense extends, LCD screen shows canon brand, camera turns itself off screen goes black with E16 in the bottom left of screen. After 10sec camera goes dead. Move slide switch to play back camera playback works correctly. ianwoodsokehampton, E16 Error is a Canon generic error code and it means that there are issues with the lens mechanism and it cannot contract/extract/focus etc. That is the reason why it works in playback mode, since it does not have to extend the lens....
Chosen Solution Hello there. I’m having an issue which is pretty much described in the title. I’m having an issue with my evaporator fan. After much investigation about why the freezer was working fine but the fridge was pretty warm, I found out that the evaporator fan only start spinning after I manually give it a little spin myself. And since I cannot be bothered to kick-start it every few hours myself, I was hoping if you could help me with this....
Chosen Solution forgot administrator password and I don’t have the disc Reboot your Mac while holding down the Command key and R. Keep holding the key combination until the loading bar appears. Once in the Recovery Mode, select Terminal from the Utilities menu. If things just got a bit too geeky for you, don’t be alarmed. If you follow the next few steps, you’ll recover your lost admin password in no time....
Chosen Solution My ASUS M51t will spin the hard drive, the fan will spin, and the USB ports work. The screen remains blank. I have tried to connect up external displays but it still shows nothing. The battery light is on and it does charge. Does anyone know if this can be fixed? Hi @carsman248 , It may be a corrupted BIOS that is causing the problem. Try a power refresh and check if that resolves it....
Chosen Solution After replacing the front glass on my iPad the Home button isn’t working. Everything else seems to be fine. If you are using the same home button and it was working before, you should remove the digitizer again, remove the adhesive that holds the digitizer and put back on temporarily to test. the contacts of the home button may not be making contact and raised slightly due to the adhesive being a bit too thick....
Chosen Solution It sounds like the home button flex was damaged. You’ll probably have to replace it to fix the problem: iPhone 5 Home Button Ribbon Cable Replacement
Chosen Solution Hi, Bought the iPhone used and the home button did not work at all, but I did manage to get to work (Don’t ask how) but then stopped working, It is as if the phone doesn’t know the home button is there! Took it down to my local repair shop and they tried a new screen no luck. They then soldered a new connector on the home button itself but still no luck....
Chosen Solution In order to operate my home button, I need to push extremely hard. What could be causing this? Do I need a new button? Is there a problem with a flex cable? Is there some other easy fix that can be done by making sure that all the parts are in place? Thanks for your help! Hi Shai Before you crack open your device, try the trick in the answer below this one....
Chosen Solution My battery connector clear plastic pull tab (which everyone use it to disconnect the connector) has been detached from the battery connector. Is there any other way to disconnect my battery connector without damaging it?! Luckily this connector is quite easy to ease out without the pull!
